Page 1 of 1
chain plate backer
Posted: August 10th, 2011, 2:04 am
by efinley
I was putting the chain plates for the side shrouds back on tonight when I notice a 1"x6" aluminum backer plate laying in the bottom of the hull. It appears to be a backer for the side shroud chain plate. I assume it goes behind the 2 horizontal screws in the chainplate? Is there one for the vertical screws too?
Thanks,
Eric
SC20 #113
Re: chain plate backer
Posted: August 12th, 2011, 12:02 pm
by Matt Haberman
Eric,
There should be an aluminum plate that goes behind all four of the screws.
Re: chain plate backer
Posted: August 12th, 2011, 4:52 pm
by efinley
My boat clearly didn't have that since I just have a piece of Al strapping with 2 holes in it. It sounds like this is a piece of Al bent to match the hull? Is this something I can get from Tom?
Re: chain plate backer
Posted: August 13th, 2011, 8:04 am
by Matt Haberman
Eric,
Call Tom next week, he should be able to help you out.