Page 1 of 1
mainsail feeder
Posted: May 12th, 2013, 10:05 am
by gahamby
Are there any pics out there of how a sail feeder is installed on the mast?
Re: mainsail feeder
Posted: May 13th, 2013, 12:13 pm
by Matt Haberman
GH,
On aluminum masts we usually do not install a fixed sail feeder on the mast, but we do use a pre-feeder that is attached to the mast base with a piece of small line. The pre-feeder acts like an extra set of hands and helps to guide the sail into the sail track. If your interested in the pre-feeder give Tom a call at 651-462-SAIL and he can set you up.
Re: mainsail feeder
Posted: May 14th, 2013, 11:59 am
by gahamby
Thanks for the reply,I'll look into it. On a different subject: Are copper rivets stock on the clew board? There was quite a bit of corrosion on mine that had to be scrubbed off.
Re: mainsail feeder
Posted: May 14th, 2013, 12:19 pm
by Matt Haberman
I don't know about copper, but Brass rivets are pretty common as they are easier to install compared to Stainless ones. They do get corroded in salt water environments and could look like copper.
Re: mainsail feeder
Posted: May 14th, 2013, 12:37 pm
by gahamby
Yes brass would be the case. Do I just keep them clean or should they be replaced?
Re: mainsail feeder
Posted: May 14th, 2013, 3:29 pm
by SC15Av8or
Hey where do you sail at?? If I remember you are in the Northern Virginia area ??? There are several of us SC sailors that go out on regular weekend sails. Come on along and we can help you out as well. Matt and Tom know us from here and calling. You are more than welcome to join us to both learn and have fun. There are 3 SC19's ....... 2 SC15's (you would make 3) and a modified SC20 that all sail in this group. Come on out...... drop me a note here and we can exchange contact info.
Re: mainsail feeder
Posted: May 16th, 2013, 9:37 am
by gahamby
Sounds great, catch me over in the "general sailor talk" page. Thanks GH
Re: mainsail feeder
Posted: May 16th, 2013, 10:47 pm
by Kevin Keller
Matt,
Can you post a picture of the pre-feeder you are talking about?
Thanks,
Kevin
Re: mainsail feeder
Posted: May 18th, 2013, 6:16 am
by Mac M
Could this possibly be it? It was in a picture Tom sent me on another subject.
Re: mainsail feeder
Posted: May 18th, 2013, 1:53 pm
by Matt Haberman
That's it!
Re: mainsail feeder
Posted: May 18th, 2013, 2:35 pm
by gahamby
It worked great until the last 1/4 of the sail, then the amount of sail overwhelmed it and the bolt rope started jamming above the gate. I need to work with it some more so it stays tight to the mast
The Harken sheave at the mast head is well worth it. It did require some filing to get it to fit.
Lot's of MC Lube was most helpful.
I tied a snatch block around the rear crossbar and turned the halyard through it so I'm pulling towards my self while braced against the front crossbar. That helped a lot.
Rained out today will work on it next week. Thanks to all for the help. GH