Page 1 of 1
supercat 19 main line rigging
Posted: July 18th, 2012, 9:13 am
by relloyd
I have a supercat 19....a novice I am. Does anyone have a photo on how to rig the main sheet. I pulled the line out of the rigging and cannot figure out how to run it back through. I replaced the line but it appears too thick. Anyone know what size line to use?
Re: supercat 19 main line rigging
Posted: July 18th, 2012, 12:21 pm
by Matt Haberman
Relloyd,
Take a look at this discussion:
viewtopic.php?f=3&t=132&p=420&hilit=mainsheet#p420
The discussion is about the mainsheet on the ARC-21 which is slightly different, but it might be enough info there for you to re-rig your SC19 mainsheet.
For the mainsheet we will commonly use a 3/8" line that has a fairly smooth jacket. This is a decent size to grasp and runs very nicely through the blocks. Avoid "Fuzzy" lines as they absorb a lot of water and dirt and do not move very smoothly through the blocks. I also personally think 1/2" line is too large in diameter even though the blocks will accept it.