Page 1 of 1
Tiller Crossbar
Posted: August 5th, 2011, 4:35 pm
by efinley
I'm embarrassed to admit this but ever since I've owned my SC20 (about 20 years now) the tiller crossbar has been a 10' stick of 3/4" EMT conduit... It needs replacing and I'm curious what the proper diameter and wall thickness was supposed to be. Can someone measure theirs?
Thanks,
Eric
Re: Tiller Crossbar
Posted: August 6th, 2011, 6:37 pm
by Paul13jg
I can't get that for you since my computer is down and maybe permanently. I did have to chuckle though. I owned a SC19 for 10 years and am still not sure about the shroud extenders(not the hyfield levers) ..as when do you use them?
Re: Tiller Crossbar
Posted: August 7th, 2011, 9:38 pm
by Eric2101
The tiller crossbar on the ARC 21 is a 3 piece assmbly. AS seen below.
---------=====---------
The 2 outer peices slide into the middle peice and are held into place with stainless set screws. This arrangement gives you room to calibrate your toe.
Eric 2101
ARC2101
Re: Tiller Crossbar
Posted: August 7th, 2011, 10:55 pm
by efinley
Do you happen to have a picture? Any idea what the OD and wall thickness is of the outer pieces? I'm guessing it is 1" but I'm trying to see how much wall thickness I want.
Re: Tiller Crossbar
Posted: September 16th, 2011, 11:50 pm
by Eric2101
sorry I have not reponded. I'll get out there and measure soon.