Page 1 of 1

ARC 21

Posted: August 10th, 2005, 7:37 pm
by Eric2101
I just bent my tiller cross bar on my ARC 21. What is the overall length of this part? I have some anodized alum tube to make the replacement but I only want to cut once....

Posted: August 10th, 2005, 9:53 pm
by Matt Haberman
Eric,
The tiller cross bar should be a three piece adjustable x-bar on your boat. It needs to be adjustable to allow for proper toe-in of the rudders. I would just measure the piece that you bent and duplicate that as the exact length is not critical as long as you have the ability to adjust.