Good day,
While connecting the standing rigging on a new to me SuperCat 17 the mast ball popped off.
The post and ball does not have a pin that goes all the way through. There is a roll pin that goes through the ball on one side, it buts up against a recessed top of the post. Right below the recessed area of the post there is a notch for the pin to seat in.
Looks like it was attached with PL5200.
Can anyone tell me what the process is for putting it back on?
If it is PL5200?
Share thoughts on PL5200 quick set vs PL5200 standard.
Would like to get it up and running asap, standard takes 4 days to cure, quickset cures in 1 day, but has 100 psi less shear strength.
I have sent a note on the above to info@aquariussails as well.
Thanks,
Don